Boilers & Hydronics

Hot-water boilers: pressure, expansion tanks, zone valves and controls.

Air in a Hot-Water Heating System: Purging, Air Separators and Vents

Why air causes no-heat zones, noise and pump problems in a hot-water heating system, how to purge bulk air with forced-water purging (and the flow you need), and where the air separator, expansion tank and vents belong. Based on Taco's technical documents.

Boiler Circulator Not Running: Power, Relay, Seized Cartridge or Air Lock?

How to tell why a hydronic circulator pump isn't moving water - no power from the relay, a seized cartridge, or air in the pump - using Taco's own instructions for "00" circulators.

Boiler Pressure Too High or Relief Valve Dripping: Expansion Tank and Fill Valve Checks

Why a hot-water boiler's pressure climbs until the relief valve weeps, and how to check the expansion tank precharge and the fill valve before replacing the relief valve.

Boiler Short Cycling: Settings, Flow, Venting or an Oversized Boiler?

A checklist for a hot-water boiler that fires, shuts off and fires again every few minutes, based on IBC's cycling troubleshooting table for its condensing boilers. Covers control settings and differential, low water flow, air, venting and condensate, and boiler size.

Hot-Water Zone Valve Troubleshooting: Valve, Motor or End Switch?

How to find out why a hydronic zone gets no heat or won't shut off. Covers how a zone valve and its end switch start the boiler, what to measure, and how to tell a bad motor head from a stuck valve.

Wiring a Nest Thermostat to a Boiler with Zone Relays: Where the C Wire Comes From

How to power a Google Nest thermostat on a two-wire (R and W) hydronic zone with a Honeywell L8124A aquastat and an Argo or Taco switching relay. Why the aquastat's C1 and C2 terminals are not a thermostat common, what the zone relay can and can't supply, and the options that work.

Tools, charts and checklists

More in Heating